Hopp til innhold
-8%

Traxxas 5340X Exhaust Header Spring Mount TRX 2.5/3.3

Art.nr: TRX 5340X

219,-

239,-

- 8%
Traxxas

Traxxas

På lager: 1

Produktet er midlertidig utsolgt. Dersom du ønsker å motta en epost når vi får det inn på lager, kan du legge igjen epostadressen din i skjemaet under.

Informasjon

Exhaust Header Spring Mount TRX 2.5/3.3

Header, exhaust (tubular aluminum, silver-anodized)/ spring mount (TRX® 2.5, 2.5R, 3.3)

Produsent

Dette er den beste merket for RC-BIL i hele Norge, nei vi kan vel si hele verden uten å trenge å være redd for at vi sier noe galt!

Relaterte produkter

 

Art.nr: TRX 5340
Copied
This is the Aluminum Exhaust Header for the Traxxas Revo.     FEATURES Aluminum construction  Silver in color  Fluted on tuned pipe end for better silicone coupler connection  Heatsink engine mounting flange   INCLUDES One Exhaust Header   REQUIREMENTS Assembly to vehicle   SPECIFICATIONS  Length: 59mm (2.32")  Pipe diameters: Outside-13mm (.52")  Inside -10mm (.40")  Width between engine exhaust mount holes: 22mm (.866")

249,-

KJØP
Art.nr: TRX 5256
Copied
O-ring, header 12.2x1mm (TRX® 2.5, 2.5R, 3.3)

19,-

KJØP
Art.nr: TRX 5245
Copied
This is the Tune Pipe Coupler and Exhaust Deflector set for the Traxxas Revo.    It allows for a connection between the Exhaust Header and the Tune Pipe. FEATURES: Silicone construction           Blue in color   INCLUDES: One Tune Pipe Coupler           One Exhaust Deflector (for use on the tune pipe)           One short Tie-Strap           Two long Tie-Straps   REQUIRES: Assembly to vehicle   SPECS:    Coupler Length:                  24mm (.95")           Coupler Inner Diameter, Large:   14mm (.55")           Coupler Inner Diameter, Small:   13mm (.51")           Coupler Outer Diameter, Large:   25mm (.98")           Coupler Outer Diameter, Small:   22mm (.87")           Deflector Length:                61mm (2.4")           Deflector Inner Diameter, Small:  8mm (.32")           Deflector Inner Diameter, Large: 10mm (.40")           Deflector Outer Diameter, Small: 11mm (.44")           Deflector Outer Diameter, Large: 14mm (.55")

49,-

KJØP
Art.nr: TRX 5245X
Copied
  This is the Rubber Tuned Pipe Coupler Set for the Traxxas Revo. FEATURES: Black rubber construction   INCLUDES: One black coupler           One black exhaust deflector           Two 7" (178mm) zip ties           Two 3" (76mm) zip ties   REQUIRES: Installing between tuned pipe and exhaust header

49,-

KJØP

Kunder kjøpte også

This is a pack of ten replacement Kyosho 13x16x0.15mm shims. These shims are used to shim the gear mesh at the ring and pinon gears for the differentials in the bulkheads of Inferno series vehicles, including the MP777,

79,-

KJØP
This is the Black Wing for the Traxxas Revo.                  This part attaches to the rear of the body. FEATURES: Plastic construction, black in color INCLUDES: One rear wing with decals REQUIRES: Installation on the Revo. SPECS:    Length: 8" (203.2mm)           Width: 3" (76.2mm)

189,-

KJØP
Header Spring TRX 2.5/3.3 Header spring/ gaskets (TRX® 2.5, 2.5R, 3.3) Header spring and gaskets for the TRX 2.5, 2.5R, and 3.3 racing engines.

39,-

KJØP
Throttle Servo Mount   Servo mount, throttle/ 4x10mm BCS (2)

49,-

KJØP
Receiver and Battery Box Multi Revo 3.3/ Slayer Pro Box, receiver & battery (2)/ cover/ foam pad & adhesive/ charge jack plug (rubber)/ 4x8mm BCS (1)/ 4x12mm BCS (2) (contains both boxes to accommodate either AA battery holder or RX flat pack) Combine this sleek receiver box with the 5394X forward-only kit to trim weight from your Revo for maximum track performance. The compact box features a tight-fitting, contamination-resistant cover, and an integrated on-off switch mount. The box can accomodate 4 AA cells, or a 5-cell rechargreable NiMH flat-pack. There's even a built-in personal transponder mount for extra convenience on race day. When converting to forward only, part 5325R completes the sleek race look and by replacing the standard servo box with a

109,-

KJØP
Brake Kit Rear Dual Disc (Requiers Center Diff #5414) Revo Brake kit, rear (dual-disc Revo®) (Requires center differential part 5414 and gearbox housing 5391X) Combine the optional center differential with the Revo dual rear brake kit to allow precise tuning of the front to rear brake bias. It's factory engineered to match Revo's top level performance and durability. (Requires center differential part 5414 and gearbox housing #5391X)

Ikke på lager
This is the Traxxas Center Differential Kit for the Revo.     FEATURES Direct drop-in for the Revo 3.3, standard chassis Revos require the  Accessory Rear Output Shaft  Transfers power to the front and rear differentials independently  Sealed center differential is adjustable using various oil  viscosities  Comes fully assembled with 100K oil   INCLUDES Traxxas Center Differential Kit for the Revo with forward-only  conversion   REQUIREMENTS Installation   COMMENTS Designed for use with rear brake kit

465,-

KJØP
This is an optional Large Knurled Flywheel for use with Starter Boxes.     FEATURES Large knurles to be gripped by rubber starter wheels  Two pin aluminum construction  Vent holes drilled to keep clutch shoes cooler   INCLUDES One 40mm flywheel   REQUIREMENTS Installation onto Traxxas nitro vehicle.   SPECIFICATIONS  Diameter: 1.6" (40mm)   COMMENTS This flywheel fits onto a tapered collet.

125,-

KJØP
These are the optional 17mm Splined Wheel Hubs. FEATURES: Aluminum construction, red anodized in color           Converts wheel hubs from 14mm to 17mm and allows the use of wheels             with 17mm hex INCLUDES: Four aluminum splined Wheel Hubs and Nuts, four 4x13mm Screw Pins REQUIRES: Installation on the vehicle

289,-

299,-

KJØP
-3%
-Disse passer til Summit 1/10 sine små TRX 2065 servoer.   This is the replacement Servo Gear Set for the Traxxas                    2065 Waterproof Sub-Micro Servo -TRX 2065            The 2065 servo is used in the E-Maxx Monster Truck Series. FEATURES: Nylon construction, white in color           Replaces worn or damaged servo gears INCLUDES: One Output Gear           One Top Reduction Gear           One Offset Reduction Gear           One Center Reduction Gear           One Bottom Reduction Gear REQUIRES: Installation

59,-

KJØP
This is the Aluminum Turnbuckle set for the                        Traxxas, Rustler and Stampede. FEATURES: Anodized aluminum construction, red in color           Black nylon ball ends INCLUDES: Two 39mm front camber links (available seperately TRX 3737)           Two 49mm rear camber links (available seperately TRX 3738)           Links are assembled with rod ends and hollow balls           One red 5mm aluminum wrench REQUIRES: Installation onto vehicle

269,-

KJØP
These are the (optional) Red Aluminum Pushrods for the Rocker Arms                         for the REVO from Traxxas         These go between the Rocker Arms and the Lower Suspension Arms           **Use with long travel or Progressive-1 Rocker Arm Set, TRX 5357.** FEATURES: Red Aluminum construction INCLUDES: Two Pushrods w/pre-installed rod ends and balls REQUIRES: Installing on the vehicle SPECS:    Length:   5.4" (137mm) end to end including rod ends           Diameter: 0.20"  (5mm) COMMENTS: For rod ends only use TRX 5347

155,-

KJØP
These are the optional Lightweight 128mm Toe Links with Rod Ends                        for the Traxxas Revo Models. FEATURES: 30% lighter than stock steel toe links           4 times stiffer and more than double the strength of aftermarket             titanium           Unique hollow tube design using 7075-T6 aluminum           Anodized red in color INCLUDES: Two Toe Links           4 Front and Rear Rod Ends           One 7mm Wrench REQUIRES: Installing on vehicle SPECS:    Length: 5.04" (128mm)           Diameter: 0.45" (11.5mm)

309,-

Ikke på lager
This is the Optional Big Bore Shock Set for the                       Traxxas T-Maxx and E-Maxx Trucks.          These replace the plastic shocks that come stock with the kit. FEATURES: Strong Alloy construction Teflon coated.           Anodized gun metal grey with red springs           Completely assembled           Comes in a foam tray covered with a clear plastic box on a hangable             header card.           Convenient 8-pack. INCLUDES: Eight fully assembled alloy shocks with red medium springs           Mounting hardware           Two bottles of shock oil (30-weight, per Traxxas) REQUIRES: Filling shocks with shock oil and assembling onto the model. SPECS:    Length: 4-1/8" (not compressed)           Diameter: 3/4" COMMENTS: This will work on both the T-Maxx and E-Maxx with no modifications.

1.149,-

1.199,-

KJØP
-4%
This is the Tune Pipe Coupler and Exhaust Deflector set for the Traxxas Revo.    It allows for a connection between the Exhaust Header and the Tune Pipe. FEATURES: Silicone construction           Blue in color   INCLUDES: One Tune Pipe Coupler           One Exhaust Deflector (for use on the tune pipe)           One short Tie-Strap           Two long Tie-Straps   REQUIRES: Assembly to vehicle   SPECS:    Coupler Length:                  24mm (.95")           Coupler Inner Diameter, Large:   14mm (.55")           Coupler Inner Diameter, Small:   13mm (.51")           Coupler Outer Diameter, Large:   25mm (.98")           Coupler Outer Diameter, Small:   22mm (.87")           Deflector Length:                61mm (2.4")           Deflector Inner Diameter, Small:  8mm (.32")           Deflector Inner Diameter, Large: 10mm (.40")           Deflector Outer Diameter, Small: 11mm (.44")           Deflector Outer Diameter, Large: 14mm (.55")

49,-

KJØP
Traxxas 2065A - Micro Servo WP Fully waterproof Fits TRX-4 and 1/10 Summit an TRX-4M Fits steering in LaTrax models Power: 2.3kg/cm Speed: 0.20 sec/60° Specification: Speed at 6,0V: 0,20 sec/60° Torque at 6,0V: 2,3 kg/cm

389,-

439,-

-11%
Electronics box, left/ box cover

89,-

KJØP
FlySky FS-GR3E receiver The FS-GR3E 3-channel receiver operates in the AFHDS system at 2.4 GHz. The receiver is compatible with FlySky GT2, GT2B, GT3, GT3B, GT3C, T6, CT6B, GR3E and TH9X transmitters. The receiver is designed for RC trucks, buggies, and boats.

219,-

249,-

KJØP
-12%
This is the replacement Right Side Electronics Box for the Traxxas Revo.  These parts attach directly to the chassis.   FEATURES Black plastic construction   INCLUDES One right electronics box  One box cover/charge jack plug  Three pieces of adhesive backed foam padding   REQUIREMENTS Nothing. These are direct replacement parts.   COMMENTS These electronics box components are designed specifically for the  Traxxas Revo and will not work for other Traxxas vehicles.

99,-

KJØP
  • klarna-dark.png
  • vipps-orange.png
  • mastercard-full.png
  • visa.png
  • paypal.png