Hopp til innhold

Traxxas 5325X Electronics Box Left

Art.nr: TRX 5325X

89,-

Traxxas

Traxxas

** Ikke på lager

Produktet er midlertidig utsolgt. Dersom du ønsker å motta en epost når vi får det inn på lager, kan du legge igjen epostadressen din i skjemaet under.

Informasjon

Electronics box, left/ box cover

Produsent

Dette er den beste merket for RC-BIL i hele Norge, nei vi kan vel si hele verden uten å trenge å være redd for at vi sier noe galt!

Kunder kjøpte også

  Gaskets, cooling head: 0.15, 0.25, 0.35mm (1 each) (TRX 2.5, 2.5R)

39,-

KJØP
Piston/sleeve (matched set), wrist pin clips(2) (TRX 3.3)

849,-

899,-

KJØP
-6%
  Bumper, rear (chrome)/ bumper mount, rear/ 4x10mm BCS (2)/ 3  

85,-

KJØP
Bumper, front (chrome)/ bumper mount, front/ 4x10mm BCS (2)/ 3x25mm BCS (2)

99,-

KJØP
 This is a Complete Fuel Tank for the Traxxas Revo.                 Holds and distributes the Fuel to the Carb FEATURES: Plastic Construction           Tight Spring on the top to prevent air leakage           Puller for opening the fuel tank quickly INCLUDES: (1) Fuel Tank REQUIRES: Installation SPECS:    Length: 3-5/8" (92mm)           Width:  2-1/4" (57mm)           Height: 3"     (76mm)

219,-

KJØP
These are Replacement Clutch Shoes for the Traxxas T-Maxx.           These mount to the flywheel and engage the clutch. FEATURES: Carbon Construction           Black in Color INCLUDES: Two Clutch Shoes           One Spring REQUIRES: Assembly into the clutch system.

95,-

KJØP
 This is the Updated Wire Harness for the EZ Start and EZ Start 2 Systems.     This harness has the white connector that the EZ Start pack plugs into. FEATURES: Extra long 12" wires           Pre-installed connectors and eyelets INCLUDES: One wire harness           One black connector bracket REQUIRES: Installation onto vehicle equipped with EZ Start or EZ Start 2. COMMENTS: The differences between this and the old design are:  Longer wire            leads, L-shaped motor connectors, and one continuous glow plug wire.

65,-

KJØP
This is the Roll Hoop/Transmission Skid Plate for the Traxxas Revo. FEATURES: Plastic construction           Black in color INCLUDES: One Roll Hoop (Roll Bar)           One Transmission Skid REQUIRES: Assembly to vehicle SPECS:    Roll Loop height:          121mm (4.76")           Transmission Skid length:  143mm (5.63") COMMENTS: If mounting screws are needed:             TRX 3938 mounting screws for the Roll Hoop.             TRX 3937 mounting screws for the Transmission Skid.             TRX 2579 mounting screws for the Servo Protectors.            Steering Servo Protectors are not included, They are stock TRX 5315

105,-

KJØP
            These are the replacement Steering Servo Guards for                   the Traxxas Nitro Revo Monster Truck. FEATURES: Nylon Construction           Black in Color INCLUDES: One Left Black Nylon Steering Servo Guard           One Right Black Nylon Steering Servo Guard REQUIRES: Assembly onto Vehicle

49,-

Ikke på lager
This is the replacement Screw Pin Set for                  the Traxxas Nitro Revo Monster Truck. FEATURES: Metal Construction           Black in Color           Hex Head Design INCLUDES: Six 4mm x 15mm Black Metal Screw Pins. REQUIRES: Assembly onto Vehicle           2mm Hex Wrench. SPECS:    Length (Overall):   15.9mm (0.62")           Length (Threads):    6.0mm (0.23")           Diameter (Threads):  3.9mm (0.15")           Diameter (Shaft):    2.5mm (0.09")

49,-

KJØP
Disse passer Traxxas 1/16 biler.   These are Replacement Traxxas Body Clips.          They can be used on Traxxas or most other brands of cars. FEATURES: Metal clips are silver in color INCLUDES: Twelve body clips SPECS:    Length: aprrox. 7/8"  

25,-

35,-

KJØP
-29%
This is the Traxxas Super Duty Long Glowplug. FEATURES: Ideal for all Traxxas engines including the 2.5, 2.5R and 3.3 engines           Suited for the varied throttle range of off-road racing           Medium heat range INCLUDES: One Traxxas Medium Heat Range Super Duty Long Glowplug with gasket REQUIRES: Plug wrench  for installing in cylinder head           Glow Fuel with 10%-20% nitro content  

119,-

139,-

Ikke på lager
-14%
FlySky FS-GR3E receiver The FS-GR3E 3-channel receiver operates in the AFHDS system at 2.4 GHz. The receiver is compatible with FlySky GT2, GT2B, GT3, GT3B, GT3C, T6, CT6B, GR3E and TH9X transmitters. The receiver is designed for RC trucks, buggies, and boats.

219,-

249,-

KJØP
-12%
Exhaust Header Spring Mount TRX 2.5/3.3 Header, exhaust (tubular aluminum, silver-anodized)/ spring mount (TRX® 2.5, 2.5R, 3.3)

219,-

239,-

KJØP
-8%
Traxxas 2065A - Micro Servo WP Fully waterproof Fits TRX-4 and 1/10 Summit an TRX-4M Fits steering in LaTrax models Power: 2.3kg/cm Speed: 0.20 sec/60° Specification: Speed at 6,0V: 0,20 sec/60° Torque at 6,0V: 2,3 kg/cm

389,-

439,-

-11%
This is the Tune Pipe Coupler and Exhaust Deflector set for the Traxxas Revo.    It allows for a connection between the Exhaust Header and the Tune Pipe. FEATURES: Silicone construction           Blue in color   INCLUDES: One Tune Pipe Coupler           One Exhaust Deflector (for use on the tune pipe)           One short Tie-Strap           Two long Tie-Straps   REQUIRES: Assembly to vehicle   SPECS:    Coupler Length:                  24mm (.95")           Coupler Inner Diameter, Large:   14mm (.55")           Coupler Inner Diameter, Small:   13mm (.51")           Coupler Outer Diameter, Large:   25mm (.98")           Coupler Outer Diameter, Small:   22mm (.87")           Deflector Length:                61mm (2.4")           Deflector Inner Diameter, Small:  8mm (.32")           Deflector Inner Diameter, Large: 10mm (.40")           Deflector Outer Diameter, Small: 11mm (.44")           Deflector Outer Diameter, Large: 14mm (.55")

49,-

KJØP
  Fuel line (610mm or 2ft)

49,-

59,-

KJØP
-17%
This is the replacement Right Side Electronics Box for the Traxxas Revo.  These parts attach directly to the chassis.   FEATURES Black plastic construction   INCLUDES One right electronics box  One box cover/charge jack plug  Three pieces of adhesive backed foam padding   REQUIREMENTS Nothing. These are direct replacement parts.   COMMENTS These electronics box components are designed specifically for the  Traxxas Revo and will not work for other Traxxas vehicles.

99,-

KJØP
This is the Front and Rear Ball Bearing set for the Traxxas 2.5 nitro engine.   FEATURES Steel Construction   INCLUDES One Front Bearing  One Rear Bearing   REQUIREMENTS None, item is a stock replacment part   SPECIFICATIONS  Front Bearing: 7mm x 17mm (5mm thick)  Rear Bearing: 12mm x 21mm (5mm thick)   COMMENTS Front Bearing features front rubber seal.

369,-

389,-

KJØP
-5%
 This is the Replacement Roller Clutch for the T-Maxx 2.5.            This is located at the EZ Start end of the crankshaft.                  This is the One Way bearing for the starter FEATURES: Steel construction   INCLUDES: One roller clutch   REQUIRES: Nothing.  This is a direct replacement part.   SPECS:    Length: 12mm (0.47")           Inner diameter: 6mm

289,-

KJØP
These are the replacement FWD/REV Output Gears for                    the Traxxas Nitro Revo Monster Truck. FEATURES: Nylon Construction           Black and White in Color   INCLUDES: One Nylon FWD Output Gear           One Nylon REV Output Gear           One White Nylon Drive Dog Carrier   REQUIRES: Assembly onto Vehicle   SPECS:    FWD Gear-            Diameter:   30mm (0.94")            Thickness: 5.8mm (0.23")            Teeth:     28T           REV Gear-            Diameter:   30mm (0.94")            Thickness: 9.5mm (0.37")            Teeth:     28T

115,-

KJØP
                      This is the Cooling Head Protector                for the Traxxas TRX 3.3 Racing Engine. FEATURES: Constructed of plastic, black in color INCLUDES: Cooling Head Protector and five 3x6mm screws REQUIRES: Fastening to top of cooling head SPECS:    Thickness: 0.18" (4.5mm)           Diameter: 1.7" (43mm)

39,-

KJØP
These are 3x5mm Backplate screws for the Traxxas 2.5 Engine. FEATURES: Black steel construction. INCLUDES: Six black steel cap head screws. REQUIRES: Assembly on coverplate. SPECS:    Length: 5mm           Diameter: 3mm COMMENTS: These may also be referred to as coverplate screws.

35,-

KJØP
This is the replacement Pivot Ball and Dust Cap Boot Set             for the Traxxas Revo, E-Revo and T-Maxx 3.3 vehicles. FEATURES: Nylon and Rubber Construction           Blue and Black in Color INCLUDES: Four Blue Rubber Pivot Ball Boots           Four Black Dust Boot Retainer           Four Blue Notched Dust Boot Retainer           Four Blue Rubber Boot Plugs           Four nylon Pivot Ball Retainers           Instruction sheet REQUIRES: Two packages needed to complete truck

89,-

99,-

KJØP
-10%
These are 3x12mm Cap Head Screws from Traxxas. FEATURES: Steel Construction           Black in color           Hex head INCLUDES: Two 3x12mm cap screws SPECS:    Length:  12mm (.47")           Diameter: 3mm (.12")

35,-

KJØP
  • klarna-dark.png
  • vipps-orange.png
  • mastercard-full.png
  • visa.png
  • paypal.png