Hopp til innhold

Traxxas 5392 Linkage Shift

Art.nr: TRX 5392

45,-

Traxxas

Traxxas

På lager: 1

Produktet er midlertidig utsolgt. Dersom du ønsker å motta en epost når vi får det inn på lager, kan du legge igjen epostadressen din i skjemaet under.

Informasjon

Linkage, shift, Revo (includes: ball collar, spring, ball cup, servo horn, linkage wire)

Produsent

Dette er den beste merket for RC-BIL i hele Norge, nei vi kan vel si hele verden uten å trenge å være redd for at vi sier noe galt!

Kunder kjøpte også

    This is the Traxxas EVX-2 Electronic Speed Control with Reverse. FEATURES: For 16 volt dual battery, dual motor setups           Three programmable drive profiles           Full-proportional reverse with brakes           EZ-Set push button setup           Waterproof design for running in mud, snow and other wet running             conditions           Low voltage detection for use with LiPo batteries           Traxxas high-current connector INCLUDES: EVX-2 ESC with Motor and Battery Wires, Receiver Wire, six Capacitors             Instructions and two Mounting Screws SPECS:    Input Voltage: 6-14 NiCd, NiMH OR 2S-4S LiPo           Case Size: 2.27 x 2.0 x 1.05" (58 x 51 x 27mm)           Weight: 4.1oz (116g) w/heat sink, 3.6oz (102g) w/o heat sink           Motor Limit (550 size): 12 turns           On Resistance Forward/Reverse (@ Trans): 0.004 Ohms           Rated Current Forward/Reverse: 180 amps           Braking Current: 360 amps           Continuous Current (@100°F amb.): 30 amps           BEC Voltage: 6.0 volts DC           BEC Current: 2.5 amps           Power Wire: 14 gauge/3" (76.2mm)           Input Harness Wire: 26 gauge/ 9.5" (241mm)           Transistor Type: MOSFET           PWM Frequency: 1700 Hertz           Protection: Thermal shutdown           Single Button Setup: Yes

1.895,-

1.995,-

KJØP
-5%
Dette er orginal dekkene til 1/10 summit.   This is a pair of Assembled and Glued Tires and Wheels                       for the Traxxas Summit 1/10 FEATURES: Canyon AT tires with angular lugs           Geode chrome plated plastic wheels with 17mm hex INCLUDES: Two Tires and Wheels for the Traxxas Summit

649,-

KJØP
This is the Clear Body for the LaTrax Teton Monster Truck from Traxxas. FEATURES Clear molded polycarbonate construction Trimmed out wheel arches and body post holes INCLUDES Latrax Teton Clear Body with Decal Sheet REQUIREMENTS Polycarbonate safe spray or brush-on paint SPECIFICATIONS Length: 9.4" (239mm) Width: 3.6" (91mm) Height: 3.3" (84mm)       (B5)

199,-

KJØP
This is the replacement Pivot Ball and Dust Cap Boot Set             for the Traxxas Revo, E-Revo and T-Maxx 3.3 vehicles. FEATURES: Nylon and Rubber Construction           Blue and Black in Color INCLUDES: Four Blue Rubber Pivot Ball Boots           Four Black Dust Boot Retainer           Four Blue Notched Dust Boot Retainer           Four Blue Rubber Boot Plugs           Four nylon Pivot Ball Retainers           Instruction sheet REQUIRES: Two packages needed to complete truck

89,-

99,-

KJØP
-10%
            These are the replacement Steering Servo Guards for                   the Traxxas Nitro Revo Monster Truck. FEATURES: Nylon Construction           Black in Color INCLUDES: One Left Black Nylon Steering Servo Guard           One Right Black Nylon Steering Servo Guard REQUIRES: Assembly onto Vehicle

49,-

Ikke på lager
  This is Tamiya Color Spray Lacquer for Polycarbonate (PS-1 White).                           For Adult Modelers Only. FEATURES: Specially developed for decorating transparent polycarbonate bodies             used in R/C car modeling.           An appropriate amount of paint for finishing one R/C model.           This paint is impervious to oil and fuels, so they can be safely             used on gas-powered R/C bodies.           The color of the lid represents the color of paint. INCLUDES: (1) Spray Can of Lacquer SPECS:    Net Volume: 100ml COMMENTS: Never use this paint on plastic models.           Highly flammable. Lakk maling sprayboks lakkboks ps.

109,-

119,-

KJØP
-8%
This is Tamiya Color Spray Lacquer for Polycarbonate (PS-45 Translucent Purple)                           For Adult Modelers Only. FEATURES: Specially developed for decorating transparent polycarbonate bodies             used in R/C car modeling.           An appropriate amount of paint for finishing one R/C model.           This paint is impervious to oil and fuels, so they can be safely             used on gas-powered R/C bodies.           The color of the lid represents the color of paint. INCLUDES: (1) Spray Can of Lacquer SPECS:    Net Volume: 3.4oz (100ml) COMMENTS: Never use this paint on plastic models.           Highly flammable.

109,-

KJØP
This is the Traxxas Power Cell 11.1V 5000mAh 25C 3S LiPo Battery.     FEATURES Semi rigid construction does not require a hard case and eliminates  wire harness connectors that can loosen and fail  Engineered specifically to fit Traxxas models  New high current connector with gold-plated copper terminals and  integrated balance connector  iD Auto Battery Identification allows Traxxas iD equipped chargers to  automatically set and optimize charge settings for specific battery  MAXX cable high-efficiency 12 gauge silicone jacketed wire   INCLUDES Traxxas Power Cell 11.1V 5000mAh 25C LiPo 3S Battery with High  Current Connector and Integrated Balance Plug   REQUIREMENTS LiPo compatible charger such as the Traxxas EZ-Peak Plus,  LiPo charging bag   SPECIFICATIONS  Configuration: 3S1P  Continuous Discharge: 25C (125A)  Max Burst Rate: 50C (250A)  Watt Hours: 55.5  Charge Rate: 1C (5A)  Max Charge Rate: 2C (10A)  Dimensions: 6.1 x 1.02 x 1.7" (155 x 26 x 44mm)  Weight: 13.3oz (376g)   COMMENTS ALWAYS use a LiPo-approved Charger  ALWAYS use a LiPo Cell Balancer  NEVER Charge over 4.20V per cell  NEVER Charge at currents greater than 1C  NEVER Trickle Charge  NEVER allow to Discharge below 3.2V per cell  NEVER disassemble or modify pack wiring in any way or puncture cells  NEVER place on combustible materials or leave unattended during  charging  ALWAYS Charge in a fireproof location  ALWAYS set charger's output volts to match battery volts  ALWAYS keep out of reach of children

995,-

1.095,-

KJØP
-9%
Electronic Speed Control, LaTrax, waterproof (assembled with bullet connectors)

679,-

699,-

KJØP
-3%
Carrier, differential, rear axle (left & right halves)

99,-

109,-

KJØP
-9%
Traxxas 5000mAh 7.4v 2-Cell 25C Short LiPo Battery TRAXXAS CERTIFIED LIPO POWER! Traxxas Certified iD-Equipped LiPo batteries are engineered to provide the punch and on-demand power for reaching the top speeds that Traxxas models are built to achieve. Traxxas Power Cell iD-Equipped LiPo batteries are engineered specifically to fit Traxxas models and maximize their full performance potential. Only Traxxas gives you more of what you want most: simple installation, a great price, and the most speed and run time available. Specs: Type: LiPo Total Capacity: 5000 mAh Voltage: 7.4 V (2S) C Rating: 25 Length: 137 mm Height: 24 mm Width: 43 mm Weight: 280 g

649,-

749,-

KJØP
-13%
Differential, rear (fully assembled)

649,-

699,-

KJØP
-7%
  Bronto ladekabler er et must for RC-entusiasten. Ladekabelen er utstyrt med kvalitets 14AWG ledninger. Ladeledningen har en praktisk lengde på 30cm, noe som er godt egnet når du f.eks skal legge batteriet trygt i en sikker ladebag mens det lades. Ladekabel med Traxxas ID plugg for 2s LiPo til 4mm bananplugger. Benyttes for lading av batterier med Traxxas ID-plugg, og kobles rett i ladere med 4mm tilkobling. Spesifikasjoner   Ledning 14AWG Lengde 30cm Tilkobling 1 4mm Banan Tilkobling 2 Traxxas ID 2s

159,-

KJØP
    Bronto ladekabler er et must for RC-entusiasten. Ladekabelen er utstyrt med kvalitets 14AWG ledninger. Ladeledningen har en praktisk lengde på 30cm, noe som er godt egnet når du f.eks skal legge batteriet trygt i en sikker ladebag mens det lades. Ladekabel med Traxxas ID plugg for 3s LiPo til 4mm bananplugger. Benyttes for lading av batterier med Traxxas ID-plugg, og kobles rett i ladere med 4mm tilkobling. Spesifikasjoner   Ledning 14AWG Lengde 30cm Tilkobling 1 4mm Banan Tilkobling 2 Traxxas ID 3s

169,-

KJØP
This is the Rear Chassis Brace for the 1/10 scale Traxxas E-Revo.     FEATURES Aluminum construction, blue in color   INCLUDES Rear Chassis Brace  Two 3x35mm Socket Head Screws  One 4x14mm Button Head Screw  Instruction Sheet   SPECIFICATIONS  Length: 5.1" (129mm)

129,-

139,-

KJØP
-7%
This is a pair of 3.8 rate (gold) Shock Springs for the Traxxas Revo. FEATURES: Red in color (small gold square indicates spring type)           Metal construction INCLUDES: 2 springs REQUIRES: Installation on the Revo SPECS:    Length:        1-11/16"      (43mm)           Inside diameter: 11/16"      (17mm)           Outside diameter:  7/8"      (22mm)           Spring Rate:       3.8

75,-

KJØP
     This is a Green Tension Shock Spring Set for the Revo GTR Shocks.              These springs are installed on the shock bodies. FEATURES: Red in color           Green band on spring indicates 3.5 tension rating INCLUDES: Two 3.5 rear shock springs REQUIRES: Nothing.  These are direct fit springs. SPECS:    Length: 90mm (3.5")           Outer diameter: 21mm (0.83")

75,-

KJØP
This is a Package of Replacement Caster Spacers for the Traxxas.                   These spacers adjust caster of the wheels. FEATURES: Black nylon construction. INCLUDES: Four caster spacers           Four caster shims REQUIRES: Nothing.  These are direct replacement parts. SPECS:    Thickness: 2mm (0.08")

39,-

KJØP
This is the Front and Rear Skid Plates for the Traxxas Revo. FEATURES: Black plastic construction           Front skid plate is a two-piece design           Rear skid plate is a one-piece design INCLUDES: Front and read skid plates          Part #5337           (8) 3X10mm button head screws       Part #2577           (1) 3X30mm button head screws       Part #2582 REQUIRES: Installation on the Traxxas Revo

99,-

KJØP
 This is the optional Shift Linkage Set for the Traxxas E-Revo FEATURES: Shift Linkage           Black nylon construction INCLUDES: One Ball Collar           One Spring           One Ball Cup           One Servo Horn           One Linkage Wire           One Shift Servo Mount           Two 3x8mm screws REQUIRES: Installation on the vehicle

59,-

KJØP
Body clip (mounting clip), angled, 90-degrees (black) (10)

39,-

KJØP
Dette produktet er erstattet med TRX 2064R Gear set, metal (for 2065X waterproof sub-micro servo)

199,-

KJØP
             This is a Long Spring Set for GTR Shocks used on the                         Traxxas Summit Monster Truck. FEATURES: Steel construction, red in color           5.4 damping rate with double orange stripe marking INCLUDES: Two Long Springs for the Traxxas GTR shocks REQUIRES: Installation on shock assembly SPECS:    Length: 2" (51mm)           Diameter: 0.87" (22.2mm)

69,-

KJØP
This is the Front LED Light Harness for use on the                   Traxxas Summit Truck 1/10 FEATURES: JST Connector           Clear LED Lights INCLUDES: Four LED Lights           Two Zip Ties REQUIRES: Installation on the vehicle

99,-

KJØP
This is the Rear LED Lights Harness for use on the                   Traxxas Summit Truck RTR. FEATURES: JST Connector INCLUDES: One Rear Harness           Six Clear LED Lights           Three Zip Ties           One Wire Clip REQUIRES: Installation on the vehicle

119,-

KJØP
  • klarna-dark.png
  • vipps-orange.png
  • mastercard-full.png
  • visa.png
  • paypal.png