This is the Traxxas EVX-2 Electronic Speed Control with Reverse.
FEATURES: For 16 volt dual battery, dual motor setups
Three programmable drive profiles
Full-proportional reverse with brakes
EZ-Set push button setup
Waterproof design for running in mud, snow and other wet running
conditions
Low voltage detection for use with LiPo batteries
Traxxas high-current connector
INCLUDES: EVX-2 ESC with Motor and Battery Wires, Receiver Wire, six Capacitors
Instructions and two Mounting Screws
SPECS: Input Voltage: 6-14 NiCd, NiMH OR 2S-4S LiPo
Case Size: 2.27 x 2.0 x 1.05" (58 x 51 x 27mm)
Weight: 4.1oz (116g) w/heat sink, 3.6oz (102g) w/o heat sink
Motor Limit (550 size): 12 turns
On Resistance Forward/Reverse (@ Trans): 0.004 Ohms
Rated Current Forward/Reverse: 180 amps
Braking Current: 360 amps
Continuous Current (@100°F amb.): 30 amps
BEC Voltage: 6.0 volts DC
BEC Current: 2.5 amps
Power Wire: 14 gauge/3" (76.2mm)
Input Harness Wire: 26 gauge/ 9.5" (241mm)
Transistor Type: MOSFET
PWM Frequency: 1700 Hertz
Protection: Thermal shutdown
Single Button Setup: Yes
Dette er den beste merket for RC-BIL i hele Norge, nei vi kan vel si hele verden uten å trenge å være redd for at vi sier noe galt!
Varenr BULK TRX 3019R
*** This is a Brand new item taken from a kit (chopped part), therefore will not have a Traxxas packaging ***...
*** This is a Brand new item taken from a kit (chopped part), therefore will not have a Traxxas packaging ***...
This is Silicone grease that is used throughout most all of the Traxxas kits, it can also be used in most any R/C...
This is the optional Steel Idler Gear for many Traxxas Vehicles. FEATURES: Steel construction INCLUDES: One...
This is the Center Half Shaft Set for the Traxxas E-Revo and E-Maxx FEATURES: Plastic construction, black in color...
This is the Traxxas replacement #3631 Front Suspension Arms for for the Stampede and Rustler. FEATURES:...
These pins slide through the axle and hold the wheel to the axle. INCLUDES: 4- stub axle pins
This is a set of the Traxxas telescoping drive shafts (equivalent of dogbones or swing shafts). These are for use on...
Denne finnes også i RPM her. This is the Large Rod End Set for the Traxxas Revo. FEATURES:...
This is a Rear Bumper and Mount for the Traxxas Summit from Traxxas. FEATURES: Black plastic with mounting...
This is the Front Bumper and Mount for the Traxxas Summit. FEATURES: Black plastic with mounting hardware...
These are 3mm Nylon Locking Nuts from Traxxas. FEATURES: Durable metal construction...
These are the optional 17mm Splined Wheel Hubs for the E-revo 1/10 and E-max 1/10 with brushmotor....
This is a Slipper Clutch Rebuild Kit for the Traxxas Revo and T-Maxx. FEATURES: Repairs...
Denne er også til dem som skal ha TRX 5552 uten X This is the Slipper Clutch Rebuild Kit for the Traxxas...
