Traxxas 7854 Long GTX Springs (0.929-Rate Orange Stripe) (2)

Art.nr: TRX 7857

Copied

Springs, shock (natural finish) (GTX) (1.450 rate) (2)

På lager 1

Art.nr: TRX 7858

Copied

Springs, shock (natural finish) (GTX) (1.538 rate) (2)

På lager 2

Art.nr: TRX 7855

Copied

Springs, shock (natural finish) (GTX) (1.199 rate) (2)

På lager 4

Art.nr: TRX 7853

Copied

Springs, shock (natural finish) (GTX) (0.824 rate) (2)

På lager 1

Art.nr: TRX 7856

Copied

Springs, shock (natural finish) (GTX) (1.346 rate) (2)

På lager 3

Art.nr: TRX 7859

Copied

Shock Springs 3.445 Rate (for GTX Medium #7861) (2) Springs, shock, medium (natural finish) (GTX) (3.445 rate, tan stripe) (2) Medium-length GTX™ shock springs are offered in different rates to tune your XRT's suspension performance or compensate for lighter or heavier vehicle configurations. The higher the spring rate number, the firmer the spring. (3.445-rate tan stripe) (1 pair)

På lager 1

Springs, shock (natural finish) (GTX) (1.199 rate) (2)

På lager 4

Stub axle, aluminum (black-anodized) (1) (use only with #7750X driveshaft)

På lager 3

Wheel nuts, splined, 17mm, serrated (black-anodized) (4)

På lager 2

RPM Threaded Hinge Pins for X-Maxx Fits* stock Traxxas A-arms as well as RPM #82352, #82354 & #82355 Quick Notes: Manufactured from stainless steel Fits* stock Traxxas A-arms as well as RPM #82352, #82354 & #82355 Can be used in place of CEN #GS025* Works in the outer, lower a-arm hinge pin location only In response to customer demand, we’re proud to release a set of threaded hinge pins for the Traxxas X-Maxx. RPM Threaded Hinge Pins work with stock Traxxas A-arms as well as RPM A-arms, are manufactured from stainless steel and are tough as nails! If you’ve lost or damaged your stock hinge pins, or perhaps you’re tired of losing those tiny hinge pin retaining screws, give RPM threaded hinge pins a shot and never look back! Tech Notes: RPM Threaded Hinge Pins are 4mm x 56mm and work in the outer, lower A-arm hinge pin location only. Each kit comes with 4 – threaded hinge pins and 4 – M3 locknuts. Our hinge pins can be used as a replacement for CEN GS025 hinge pins as well but RPM versions use a 3mm locknut instead of a 4mm version. When used with the X-Maxx (using stock or RPM A-arms), some minor modification of the A-arms is required for the hinge pins to fit (see instructions for more information).

På lager 5