Hopp til innhold

Nine Eagles NE401772001A Propeller

Art.nr: NE401772001A

59,-

På lager: 2

Produktet er midlertidig utsolgt. Dersom du ønsker å motta en epost når vi får det inn på lager, kan du legge igjen epostadressen din i skjemaet under.

Kunder kjøpte også

KJØP
Kvalitets NiMh pakke med meget høye utladings egenskaper! Rimelig pakke som leverer! Kapasitet på 4200 mAh Spenning er 7.2V Lengde: 135mm Høyde:    24mm Bredde:   46mm TAMIYA CONNECTOR

399,-

KJØP
Vertical Tail and Horizontal Tail x 1 Set

119,-

KJØP
 Fuselage Set – Sky Runner

159,-

KJØP
Denne er også til dem som skal ha TRX 5552 og 5552X This is the Slipper Clutch Rebuild Kit for the Traxxas Slash 4x4 Vehicles. FEATURES: Steel construction INCLUDES: One Steel Disc           Three Friction Pads           Two Springs           One 4mm Lock Nut           One 5mm Lock Nut           Instructions REQUIRES: Disassembly of slipper clutch

119,-

Ikke på lager
This is a Traxxas 48P, 86T Spur Gear for models with                        Torque Control Slipper Clutch. FEATURES: 48 pitch           86 tooth           Designed for models with a slipper clutch.           Black plastic construction INCLUDES: One spur gear SPECS:    Pitch:   48           Tooth:   86

39,-

KJØP
This is a pair of optional Front Driveshafts                     for the 1/10 scale Traxxas Slash 4x4. FEATURES: Harddened steel construction INCLUDES: Two Front Driveshafts   Traxxas Steel Constant Velocity Shafts offer the ultimate in torque handling and efficient power transfer. The outer U-joints are lubricated and sealed by a rubber boot for maximum protection against the elements, and the U-joint pins are held captive so you never have to worry about losing a pin. Gleaming nickel-plated shafts and black silicone boots add a custom look.

799,-

949,-

KJØP
-16%
This is the optional Low CG Chassis Conversion Kit for the                         Traxxas 1/10 scale Slash 4x4. FEATURES: 1" (25.4mm) lower than stock chassis           Holds battery and electronics as deep in the chassis as possible to             to enhance handling and increase cornering speed           Plastic chassis is reinforced by integrated ribs to prevent flex             under load           Smooth underside to reduce drag and prevent snags           Integrated personal transponder mount           Complete kit, no extra parts needed INCLUDES: Chassis           Two Nerf Bars           Front and Rear Bulkheads           Motor Mount and Plate           Battery Hold Down           Front and Rear Hold-down Retainers           Servo Horn           Steering Linkage           Waterproof Receiver Box with O-Ring Seal           Gear Cover           Wire Retainer           Complete Hardware Set

869,-

899,-

KJØP
-3%
  • klarna-dark.png
  • vipps-orange.png
  • mastercard-full.png
  • visa.png
  • paypal.png