Hopp til innhold

Traxxas 5779 Rudder Alu DCB M41

Art.nr: TRX 5779

319,-

Traxxas

Traxxas

På lager: 1

På lager i vår butikk i Oslo

Produktet er midlertidig utsolgt. Dersom du ønsker å motta en epost når vi får det inn på lager, kan du legge igjen epostadressen din i skjemaet under.

Informasjon

Rudder (127.5 mm)/ rudder arm/ hinge pin/ 3x15mm BCS (stainless) (2)/ NL 3.0 (2)/ 4x3mm BCS (stainless, with threadlock) (1)

Produsent

Dette er den beste merket for RC-BIL i hele Norge, nei vi kan vel si hele verden uten å trenge å være redd for at vi sier noe galt!

Kunder kjøpte også

Rudder mount/ rudder pivot/ 4x14mm BCS (stainless) (4)/ NL 4.0 (2)

199,-

På lager 1
KJØP
Traxxas 5733R - Propeller, 42x59mm (steel)/ M4x0.7 NL (1) (requires installation of #5742X aluminum rudder mount for Spartan® SR) Upgrade your Spartan® or DCB-M41 with this high-performance steel 42x59 mm prop. Includes locknut. Steel prop requires aluminum rudder mount (5742X) if not already installed.

269,-

299,-

På lager 1
KJØP
-10%
  Motor mount/ flex cable guard, DCB M41

99,-

På lager 2
KJØP
Mount, stuffing tube (upper & lower)/ 4x10mm BCS (stainless) (2)/ 3x10mm CS (stainless) (2)

59,-

På lager 1
KJØP
Radio tray/ radio tray retainer (2)/ 4x16mm BCS (stainless) (2)

149,-

På lager 1
KJØP
Propeller shaft/ flex cable, DCB M41 (380.9mm)

219,-

** Ikke på lager
KJØP
  Drive Strut Alu DCB M41

249,-

259,-

** Ikke på lager
KJØP
-4%
Mount, drive strut (2)

149,-

På lager 1
KJØP
Rudder pushrod, assembled/ servo horn/ 3x18mm BCS (stainless) (1)/ 3x15mm CS (stainless) (1)/ 3x6mm CS (stainless) (1)/ NL 3.0 (1)

89,-

** Ikke på lager
KJØP
Motor coupler, collet style/ GS 4x3 SS (with threadlock) (1)/ wrench, 10mm (2)

169,-

På lager 2
KJØP
This is the Hardware Kit for the Traxxas Spartan and DCB-M41 40" Catamaran. FEATURES Stainless steel construction INCLUDES All Screws and Nuts used in the assembly of the Spartan and DCB-M41

199,-

På lager 16
KJØP
 This is a package of Water Cooling Tubing for the Traxxas Spartan. FEATURES: Silicone construction, blue in color INCLUDES: One 3' length of fuel tubing SPECS:    Inside diameter:  .101" (2.5mm)           Outside diameter: .212" (5.5mm)           Length: 1m (39")

69,-

Ikke på lager
Ikke på lager
These are the Stock Trim Tabs for the Traxxas Spartan Race Boat. FEATURES: Stainless steel construction           Pre-drilled for mounting INCLUDES: Two trim tabs w/mounting hardware REQUIRES: Installation

75,-

På lager 2
KJØP
This is the Rubber Boot for the Rudder Pushrod for the Traxxas Spartan. FEATURES: Rubber construction           Blue in color INCLUDES: One rubber boot and mount REQUIRES: Installation

29,-

På lager 7
KJØP
This is the Receiver Box for use on the               Traxxas Stampede, Rustler, and Bandit Vehicles. FEATURES: Nylon construction           Black in color INCLUDES: One Receiver Box           One Rubber Seal           Foam Padding           Two 2.5x8mm Cap Head Screws           Two 3x10mm Cap Head Screws           Two 2.5x10mm Cap Head Screws           One Tube of Grease           Instruction sheet REQUIRES: Installation on the vehicle SPECS:    Length: 78mm (3.07")           Width: 35mm (1.4")           Height: 33mm (1.3")

145,-

Ikke på lager
Ikke på lager
This is the stock 42x59 Propeller for the Spartan Boat from Traxxas. FEATURES: Black nylon construction INCLUDES: One 42x59 propeller REQUIRES: Installation on propeller shaft SPECS:    Shaft Diameter: 4mm

59,-

På lager 10
KJØP
Traxxas 10450 - Tripple Axle Boat Trailer Transport your Traxxas boat to the lake in style with this fully detailed scale replica triple-axle trailer. Adjustable bunk brackets accommodate either the Spartan’s deep-V hull or the DCB-M41’s catamaran hull. Elastic tie-downs hold the boat securely to the trailer’s lightweight, full-length aluminum frame. You can even challenge your trailering skills by backing the trailer onto the ramp using your TRX-4 or Traxxas Ford® Raptor R™ with the included variable-height hitches. The boat trailer is authentic down to the smallest detail with a folding jack stand, variable-height hitch, and lenses for the optional LED light kit. There’s even a mount to use the Traxxas Pro Scale®Winch to haul your boat out of the water. Boat Trailer Features: ­Adjustable bunk brackets Elastic tie downs hold the boat securely Variable height hitch Fold-down trailer jack stand Lightweight aluminum frame LED-Ready light lenses Accommodates Pro Scale Winch Fits: Traxxas Ford Raptor R 4x4 Traxxas TRX-4 High Trail Traxxas TRX-4 Traxxas TRX-6

2.495,-

2.695,-

På lager 2
KJØP
-7%
Stuffing tube (assembled with liner)

169,-

** Ikke på lager
KJØP
  • klarna-dark.png
  • vipps-orange.png
  • mastercard-full.png
  • visa.png
  • paypal.png