Hopp til innhold

Slash 4x4 Ultimate Low-CG Chassi

Populært i denne kategorien

 
Art.nr: TRX 6852R
Copied
This is a pair of optional Rear Driveshafts                     for the 1/10 scale Traxxas Slash 4x4. FEATURES: Harddened steel construction INCLUDES: Two Rear Driveshafts Traxxas Steel Constant Velocity Shafts offer the ultimate in torque handling and efficient power transfer. The outer U-joints are lubricated and sealed by a rubber boot for maximum protection against the elements, and the U-joint pins are held captive so you never have to worry about losing a pin. Gleaming nickel-plated shafts and black silicone boots add a custom look.  

799,-

949,-

Ikke på lager
-16%
Art.nr: TRX 6893G
Copied
Bearing adapter, 6061-T6 aluminum (green-anodized) (1)/ 10x15x4mm ball bearing (black rubber sealed) (1) (for slipper shaft)

69,-

KJØP
Art.nr: TRX 6893X
Copied
This is an optional Bearing Adapter for the Slash 4X4. FEATURES: 6061-T6 anodized blue aluminum construction           Steel 10x15x4mm ball bearing with blue rubber seal           Used on slipper shaft INCLUDES: One aluminum adapter           One 10x15x4mm ball bearing REQUIRES: Installation on to slipper shaft           Remaining clutch pieces

69,-

KJØP
Art.nr: TRX 6894
Copied
LED light set, complete (includes front and rear bumpers with LED light bar, rear LED harness, & BEC Y-harness) (fits 4WD Slash) Traxxas LED light kits are built tough, with factory fit and finish for easy installation. Designed specifically for Slash 4X4 models, the kit includes 4 brilliant white forward-facing LEDs and two rear-facing red LEDs to enhance rear visibility. The kit is fully waterproof, and includes everything needed for installation.

629,-

649,-

KJØP
-3%
Art.nr: TRX 6898
Copied
This is the optional Sway Bar Kit for the Traxxas Slash 4x4. FEATURES: For front and rear application to reduce chassis roll in turns and             add stability INCLUDES: Two thick and two thin swaybars, two mounts, two linkage sets,             mounting haardware and instructions REQUIRES: Installing at front and rear of chassis

339,-

359,-

KJØP
-6%
Art.nr: TRX 6928
Copied
Traxxas 6928 Body conversion kit, Slash 4X4 (includes front & rear body mounts, latches, hardware) (for clipless mounting) The Slash® 4X4 clipless body conversion kit allows you to convert your 1/10 scale 4X4 Slash chassis and body to the convenience and style of clipless body mounting. Wide latch mounts cover the existing body mount holes to provide a secure mounting point that helps prevent pull-through damage. The kit includes all mounting hardware and adhesive templates. Accessory part for these models: Slash 4X4 Ultimate Slash 4X4 VXL Slash® 4X4 Brushless Slash 4X4

399,-

419,-

KJØP
-5%
Art.nr: TRX 6932-GRN
Copied
Traxxas 6932-GRN Body Slash 4x4 Green (for Clipless Mounting) Body, Slash 4X4 (also fits Slash VXL & Slash 2WD), green (painted, decals applied) (assembled with front & rear latches for clipless mounting) Is it time to upgrade your Slash® with an all-new look? This clipless polycarbonate body features the hottest ProGraphix® paint with pre-applied decals. There’s no need to trim the body because Traxxas pre-painted bodies come ready to mount right out of the bag. Body comes assembled with front and rear clipless latches. Older Slash chassis without clipless mounts will require 6940 (2WD) or 6976 and 10125 (4X4) in order to mount the body. Accessory part for these models: Slash 4X4 Ultimate (clipless) Slash 4X4 VXL (clipless) Slash Brushless (clipless) Slash VXL (clipless) Slash (clipless) Car Type: Short Course Scale: 1/10 Painted: Yes

919,-

969,-

KJØP
-5%
Art.nr: TRX 6932-RED
Copied
Traxxas 6932-RED Body Slash 4x4 red (for Clipless Mounting) Body, Slash 4X4 (also fits Slash VXL & Slash 2WD), Red (painted, decals applied) (assembled with front & rear latches for clipless mounting) Is it time to upgrade your Slash® with an all-new look? This clipless polycarbonate body features the hottest ProGraphix® paint with pre-applied decals. There’s no need to trim the body because Traxxas pre-painted bodies come ready to mount right out of the bag. Body comes assembled with front and rear clipless latches. Older Slash chassis without clipless mounts will require 6940 (2WD) or 6976 and 10125 (4X4) in order to mount the body. Accessory part for these models: Slash 4X4 Ultimate (clipless) Slash 4X4 VXL (clipless) Slash Brushless (clipless) Slash VXL (clipless) Slash (clipless) Car Type: Short Course Scale: 1/10 Painted: Yes

919,-

969,-

KJØP
-5%
Art.nr: TRX 6932L
Copied
Traxxas 6932L Body Slash 4x4 Prographix (for Clipless Mounting)) Body, Slash 4X4, ProGraphix (graphics are printed, requires paint & final color application)/ body mount latch (front & rear)/ latch mounts/ decal sheet From mild to wild, choose your own colors to personalize your clipless Slash body. The detailed graphics are fully painted, but the rest of the body is clear, so you can choose your own main body color. It's easy for anyone to get instant, professional results. Traxxas ProGraphix bodies come completely trimmed with pre-drilled body post holes for easy installation. A protective overspray film is applied to the body for convenience. Includes decal sheet and front & rear latch mounts and latches. Older Slash chassis without clipless mounts will require 6940 (2WD) or 6976 and 10125 (4X4) in order to mount the body. Accessory part for these models: Slash 4X4 Ultimate (clipless) Slash 4X4 VXL (clipless) Slash Brushless (clipless) Slash VXL (clipless) Slash (clipless) Car Type: Short Course Scale: 1/10 Painted: Yes

619,-

649,-

KJØP
-5%
Art.nr: TRX 6934
Copied
Traxxas 6934 Conversion Kit Clipless Body Slash Body conversion kit, Slash 2WD/Slash 4X4 (includes front & rear latch mounts, latches, hardware) (for clipless mounting) The Slash clipless body conversion kit allows you to convert your 1/10 scale Slash body (2WD or 4X4) to the convenience and style of clipless body mounting. Wide latch mounts cover the existing body mount holes to provide a secure mounting point that helps prevent pull-through damage.

265,-

285,-

KJØP
-7%
Art.nr: TRX 6966
Copied
Traxxas 6966 - Clipless Latch Mounts Latch mounts/ retainers (front & rear, left & right) Complete set of front and rear latch mounts and retainers for 1/10 scale Slash clipless bodies. Extra-wide retainers keep a firm hold on the body and reduce pull-though damage associated with body clips. Requires 6967 body latch mounts (sold separately). Replacement part for these models: Slash 4X4 Ultimate Slash 4X4 VXL Slash VXL Slash Accessory part for these models: Slash 2WD Unassembled Kit Slash 4X4 Ultimate Slash 4X4 VXL Slash 4X4 Slash VXL Slash Slash® 4X4 Brushless

89,-

KJØP
Art.nr: TRX 6992
Copied
Traxxas 6992 Roof Skid Pads for Slash Body 6958 Skid pads, roof (left & right)/ retainers (left & right)/ 3x10mm CS (6) (fits #6958 body) Roof skid pads (left and right) with retainers and screws, for #6958-series bodies Replacement part for these models: Slash® 2WD Slash® VXL Slash® 4X4

79,-

99,-

KJØP
-20%
Art.nr: TRX 7426X
Copied
 This is the Battery Hold-downs and Tall Retainers                   for the Traxxas 1/10 Rally VXL rally car FEATURES: Made of black plastic. INCLUDES: One battery hold-down           One tall front hold-down retainer           One tall rear hold-down retainer SPECS:    hold-down, length:         7-5/8" (194mm)                      width:          1-1/4" (32mm)                      height:         3/8"   (10mm)           front retainer, length:    46mm   (1-13/16")                           width:     50mm   (2")                           thickness: 8.5mm  (5/16")           rear retainer, length:     48mm   (1-7/8")                          width:      42mm   (1-5/8")                          thickness:  17mm   (11/16") COMMENTS: The tall hold-down retainers allow for the use of taller,              multi-cell batteries.

89,-

99,-

KJØP
-10%
Art.nr: TRX 7440
Copied
  This is the set of Traxxas Long GTR Shock Springs                     with 0.623 Orange Compression Rate. FEATURES: Steel construction, white in color           Dab of paint on end of spring indicates compression rate INCLUDES: Two Long 0.623 Orange Rate GTR Shock Springs SPECS:    Length: 2.04" (52mm)           Wire Diameter: 0.043" (1.1mm)

59,-

KJØP
Art.nr: TRX 7441
Copied
This is the set of Traxxas Long GTR Shock Springs                     with 0.653 Green Compression Rate. FEATURES: Steel construction, white in color           Dab of paint on end of spring indicates compression rate INCLUDES: Two Long 0.653 Green Rate GTR Shock Springs SPECS:    Length: 2.04" (52mm)           Wire Diameter: 0.043" (1.1mm)

59,-

KJØP
Art.nr: TRX 7442
Copied
This is the set of Traxxas Extra Extra Long GTR Shock Springs                     with 0.711 Orange Compression Rate. FEATURES: Steel construction, white in color           Dab of paint on end of spring indicates compression rate INCLUDES: Two Extra Extra Long 0.711 Orange Rate GTR Shock Springs SPECS:    Length: 2.4" (60mm)           Wire Diameter: 0.043" (1.1mm)

59,-

KJØP
Art.nr: TRX 7443
Copied
  This is the set of Traxxas Extra Extra Long GTR Shock Springs                     with 0.762 Green Compression Rate. FEATURES: Steel construction, white in color           Dab of paint on end of spring indicates compression rate INCLUDES: Two Extra Extra Long 0.762 Green Rate GTR Shock Springs SPECS:    Length: 2.4" (60mm)           Wire Diameter: 0.043" (1.1mm)

59,-

KJØP
Art.nr: TRX 7444
Copied
This is a pair of Long Shock Springs for the                    Traxxas GTR Long Shocks. FEATURES: Steel construction, white in color           0.767 (black) compression rating INCLUDES: Two XX-Long Shock Springs SPECS:    Length: 1.8" (47mm)           Wire Diameter: 0.039" (1mm)

69,-

KJØP
Art.nr: TRX 7445
Copied
This is the set of Traxxas Long GTR Shock Springs                     with 0.810 Pink Compression Rate. FEATURES: Steel construction, white in color           Dab of paint on end of spring indicates compression rate INCLUDES: Two Long 0.810 Pink Rate GTR Shock Springs SPECS:    Length: 1.8" (45mm)           Wire Diameter: 0.043" (1.1mm)  

69,-

KJØP
Art.nr: TRX 7446
Copied
This is a pair of XX-Long Shock Springs for the                    Traxxas GTR XX-Long Shocks. FEATURES: Steel construction, white in color           0.874 (black) compression rating INCLUDES: Two XX-Long Shock Springs SPECS:    Length: 2.2" (57mm)           Wire Diameter: 0.059" (1.5mm)

59,-

KJØP
Art.nr: TRX 7447
Copied
   This is the set of Traxxas Extra Extra Long GTR Shock Springs                     with 0.884 Pink Compression Rate. FEATURES: Steel construction, white in color           Dab of paint on end of spring indicates compression rate INCLUDES: Two Extra Extra Long 0.884 Pink Rate GTR Shock Springs SPECS:    Length: 2.2" (56mm)           Wire Diameter: 0.043" (1.1mm)

59,-

KJØP
Art.nr: TRX 7448
Copied
 This is the set of Traxxas Long GTR Shock Springs                       with 0.892 Blue Compression Rate. FEATURES: Steel construction, white in color           Dab of paint on end of spring indicates compression rate INCLUDES: Two Long 0.892 Blue Rate GTR Shock Springs SPECS:    Length: 1.8" (45mm)           Wire Diameter: 0.043" (1.1mm)

69,-

KJØP
Art.nr: TRX 7449
Copied
This is the set of Traxxas Extra Extra Long GTR Shock Springs                       with 1.004 Blue Compression Rate. FEATURES: Steel construction, white in color           Dab of paint on end of spring indicates compression rate INCLUDES: Two Extra Extra Long 1.004 Blue Rate GTR Shock Springs SPECS:    Length: 2.2" (56mm)           Wire Diameter: 0.043" (1.1mm)

59,-

69,-

KJØP
-14%
Art.nr: TRX 7461
Copied
Shocks, GTR long blue-anodized, PTFE-coated bodies with TiN shafts (fully assembled, without springs) (2)

429,-

449,-

KJØP
-4%
Art.nr: TRX 7461G
Copied
Shocks, GTR long green-anodized, PTFE-coated bodies with TiN shafts (fully assembled, without springs) (2)

429,-

449,-

KJØP
-4%
Viser 101 til 125 (av 204 produkter)
  • klarna-dark.png
  • vipps-orange.png
  • mastercard-full.png
  • visa.png
  • paypal.png