SAMIRC
Lukk
Handlekurven er tom

Subtotal: 0,-

Novak 3146 Kinetic/Ballistic system 10.5t

Art.nr: 3146
1.390,- 2.090,- -33%

Produktet er midlertidig utsolgt. Dersom du ønsker å motta en epost når vi får det inn på lager kan du legge igjen epostadressen din i skjemaet under.

På lager: 1

This is the Team Novak Kinetic Racing Brushless ESC in a brushless combo with a 10.5 turn motor.

 

KINETIC/BALLISTIC RACING BRUSHLESS SYSTEM FEATURES

Novak's Dynamic Timing Advance™ increases the motor's RPM dynamically through the throttle band

Maximum-available electronic-motor timing – more than 50 degrees plus boost with eight on-board settings
Compatible with the NovaLink™ for advanced programming options including fine tuning of timing, ESC and motor temperature diagnostics and adjustable boost delay
Software updates for the Kinetic can be updated via the NovaLink™
Electronic Power Control™ feature to fine tune vehicle power delivery and response
Multiple adjustable parameters via on-board or optional PC interface: Minimum Brake (0-30%), Drag Brake (0-30%), Minimum Drive (0-15%), Timing Level (0-55° + boost), Timing Set Point (19,500-4,000), Current Limit (10 settings), Dead Band (2-8%), Throttle Curve (Linear/Expo), Brake Curve (Linear/Expo),  Brake Frequency (1.67-13.7 KHz), Brake End Point (10-100%), Drive Frequency (16-7 KHz),  Reverse, Motor Rotation, Voltage Cut-Off, Hall Sensor Test and Throttle Profile
Approved for ROAR Sportsman Class Racing
On-board Hall Sensor Test to easily and quickly verify that the motor's sensors are working properly
NovaBrakes™ provide instantaneous braking under any timing condition
Sensor-based for excellent torque and low-speed driveability
User friendly on-board programming interface with five colored status LEDs
Robust 3-amp BEC for strong and fast steering response under any condition
Compatible with the entire 540-sized and 550-sized Novak brushless motor line

Battery Type Selection circuitry for Li-Po, Li-Fe and Ni-MH battery packs

Locked Rotor Detection and Thermal Overload Protection with on-board temperature diagnostics
Included 25x25x10mm ESC cooling fan (#5649)
Eight layered, 2 oz., copper-clad PC board for lowest possible power loss
Water-resistant case with a protective silicone gasket
Cross-cut ESC heat sink for reduced weight and efficient cooling
The Kinetic's firmware can be updated via a PC using the NovaLink™
Oversized front bearing (1/2” x 3/16”) for increased load handling and bearing life
Rebuildable motor design with removable shielded sensor harness, rotor, sensor assembly, wound stator, bearing, bearing cap, hardware, sleeve and both end bells
Nickel-plated, sintered Neodymium rotor with a 0.125” pinion shaft that accepts all existing pinion gears
Meets RoHS compliance and includes 120-Day Warranty
Designed, assembled and tested by Novak in Irvine, Calif., using globally sourced components
 
KINETIC/BALLISTIC RACING BRUSHLESS SYSTEM SPECS
System Motor Turns
5.5T
6.5T
7.5T
8.5T
10.5T
13.5T
17.5T
21.5T
Part Number
#3142
#3143
#3144
#3145
#3146
#3147
#3148
#3149
Color-Coded Stator
Black
Black
Black
Black
Blue
Orange
Yellow
Green
KV (unloaded)
7,400 Kv
6,400 Kv
5,800 Kv
5,000 Kv
4,200 Kv
3,300 Kv
2,200 Kv
1,800 Kv
Watts @ 7.2V
420
390
340
280
235
195
130
85
Design
Sensor Based
Sensor Harness
9" (230mm)
Motor Size
2.07" x 1.41" (52.6 x 35.8mm)
Product Weight 
(w/o wires)
1.29 oz. (36.60 g) [ESC weight w/o wires], 7.89 oz. (223.68 g) [System weight w/o wires]
Input Voltage
2S Li-Po cells, 2S Li-Fe cells or 4-6 NiMH cells (1.2V/cell)
ESC Footprint
1.16” x 1.47” (29.5 x 37.3 mm)
Motor Limit
Any ROAR-approved 540-sized* and 550-sized sensored brushless motor
On-Resistance
0.00040 ohms @ 25°C trans. temp.
BEC
6.0 volts DC / 3.0 amps
Status LEDs
5
Voltage Cut-Offs
6.25V (Li-Po), 4.75V (Li-Fe) [adjustable via NovaLink™]
Power Wires (battery/motor)
14G Super-Flex Copper-Strand Silicone Wire

*Advanced motor timing must not be used for 3.5 to 5.5-turn 540-sized motors

 

Relaterte produkter

Kunder kjøpte også

Trykk Enter for å søke eller Esc for å lukke