Hopp til innhold

Jperkins 5509889 Li-Po Regulator 6.0 Volt (5 Amp) BEC

Art.nr: 5509889

199,-

J Perkins

J Perkins

** Ikke på lager

Produktet er midlertidig utsolgt. Dersom du ønsker å motta en epost når vi får det inn på lager, kan du legge igjen epostadressen din i skjemaet under.

Informasjon

This Cunning little unit allows the use of any battery from 7 to 25 volts to run your RX flight pack.

◾Input Voltage - 7v to 25v

◾Output Regulated Voltage - 6.0v

◾Output Amps - 5A

◾Weight - 19g

◾Size - 20x15x49mm

Produsent

Kunder kjøpte også

Vapex Li-Po Battery 2S 7.4V 1300mAh 30C T-Connector Suitable for: Airplanes & Boats etc Battery: LiPo 2S 7.4V 1300mAh 30C 9.5Wh Max Discharge: 39A Continuous / 78A Burst Charge: Max 3C/3.9A (fast) Connector: T Wire: 13AWG Balance Connector: XH Length: 71.5 mm Width: 33 mm Height: 14.4 mm Weight: 70 g

199,-

KJØP
 This is Tamiya Color Spray Lacquer for Polycarbonate (PS-34 Bright Red).                           For Adult Modelers Only. FEATURES: Specially developed for decorating transparent polycarbonate bodies             used in R/C car modeling.           An appropriate amount of paint for finishing one R/C model.           This paint is impervious to oil and fuels, so they can be safely             used on gas-powered R/C bodies.           The color of the lid represents the color of paint. INCLUDES: (1) Spray Can of Lacquer SPECS:    Net Volume: 100ml COMMENTS: Never use this paint on plastic models.           Highly flammable.

109,-

KJØP
This is a Heavy Duty 24" Servo Extension with Hitec-S, JR, Airtronics-Z Connectors. This extension goes between the receiver and the servo to make the wire longer. On one end of the wire is a male connector and on the other end of the wire is a female connector. FEATURES Gold-plated teminals improve conductivity and prevent oxidation for longer lifespan. Heavier, 20-gauge wire handles higher current loads. INCLUDES One 24" Long Servo Extension w/Hitec-S, JR, Airtronics-Z Style Connectors SPECIFICATIONS Wire Gauge: 20

59,-

KJØP
KJØP
This is a Castle Creations Blower Fan for 1/10 scale motors. FEATURES Black hard plastic case INCLUDES One fan with preinstalled wire and Futaba connector REQUIREMENTS Attaching fan to motor Plugging fan into receiver Installation around motor can

239,-

KJØP
These are the Battery Straps for the Spartan Boat from Traxxas FEATURES Black color velcro strap INCLUDES 4 battery straps SPECIFICATIONS Length: 9" (228mm) Width: .62" (16mm)

79,-

KJØP
This is the Rear Body Mount for the HPI WR8 Flux Rally Car from HPI.     FEATURES Plastic construction  Installs at rear of chassis and holds rear body posts in place   INCLUDES Rear Body Mount

59,-

KJØP
  Crawler Tires on 1.9" Wheels - FRONT & REAR Fits: Right 1/10 Rock Crawler Axial SCX10 Also fits other 1/10 Scale Crawlers with 12 mm hexes Specs: Wheel diameter: 1.9" Tire Diameter: 123 mm Tire Width: 49 mm Weight (each): 123 g Hex: 12 mm Tire Compound: Super Soft Wheel finish: Chrome Black Nylon     Outer Diameter: 123 mm Scale: 1/10 Size: 1,9 Inch Suit: Crawler Compound: Super Soft Width: 49 mm Drive: 12mm Hex

299,-

329,-

KJØP
-9%
VAPEX LiPo-Safe Storage Bag-E 260x130x150mm Protect your family and home from the potential hazard of LiPo charging. This LiPo Safe Bag is designed to limit and contain the fire caused by incorrectly or poorly functioning LiPo's, especially during charging but also during storage. Features: Perfect storage bag for most RC batteries Zipper Flap/Top Bag-A, B, C & D fits inside it Size: 260x130x150mm We urge all customers to always practice extreme caution when charging and never leave a charging battery unattended! Warning: Never leave batteries unattended while being charged Always ensure the battery and the LiPo Safe Bag is placed on a non-flammable surface such as concrete Always seal the LiPo Safe Bag while charging The LiPo Safe Bag is intended to reduce the chances of damage in the event of a LiPo fire

169,-

189,-

KJØP
-11%
Sport Performance 3S 30C 1800 mAh LiPo Battery   Application: Any Airplane, Heli, Drone, Car or Boat that needs a 3S pack with T-connector Type: Sport Performance Battery: 3S/11.1V 30C LiPo Capacity: 1800 mAh Energy: 20Wh Discharge: Max 30C/54A cont & 60C/108A peak Charging: Max 3C/5.4A Size: 105 x 35 x 21.7 mm Weight: 154 g Wires: 13AWG Power Connector: T Balance Connector: XH

299,-

KJØP
The Velineon® VXL-3s Accessory Cooling Fan reduces ESC temperatures during extended operation for maximum power flow. It securely clips onto the VXL-3s heatsink for easy installation. Wires are neatly routed thanks to the integrated connector clip. Simply plug the accessory cooling fan into the Velineon VXL-3s accessory power connector and clip the fan onto the heatsink for increased cooling.  

299,-

329,-

KJØP
-9%
Tips! Denne passer til TRX-4 Ford Bronco 2021. TRX4 Land Rover Defender LED Light Set LED light set, complete with power supply (contains headlights, tail lights, roof light bar, rock lights & distribution block) (fits #8011 & 8050 body) Kit Contents: LED lighting module Distribution block Distribution block mount LED light bar LED rock light harness assembly LED headlight harness assembly LED tail light harness assembly 4-in-2 wire harness 2.6x8mm button-head cap screws (2) 2.5x15mm cap screws (2) 2.5x6mm cap screws (2) Zip ties (9) Tools required: 2.0mm hex wrench 1.5mm hex wrench Side cutters (to trim zip ties)

1.249,-

1.349,-

KJØP
-7%
Traxxas 6591 - Pro Scale Lighting Kit Traxxas LED lighting sets the standard for adventure after dark with authentic shadow-chasing brightness on the trail. Now, Traxxas LED lighting is even more realistic with the new Pro Scale Advanced Lighting Control System. The Pro Scale system puts you in command of high- and low-beam headlights; turn signals; brake lights; reverse lights; and even hazard signals for the ultimate in scale off-roading. Kit Contents: Pro Scale Lighting Power Module Power module chassis mount Pro Scale Lighting Distribution Block Motor sense wire harness Breakaway cable (part of the distribution block) MAXX® Link cable (Data Link) (TQi Radio System only) Receiver communication cable 2.6x8mm button-head cap screw (2) 2.5x10mm countersunk cap screw (1) 2.5x12mm cap screw (1) 2.5x18mm cap screw (1) Zip ties (10) Silicone grease Tools required: 2.0mm hex wrench (part #3415, sold separately) Wire cutters (to trim zip ties) Small needle nose pliers *Requires Traxxas Link App (available in the Apple App Store™ or on Google Play™) and TQi transmitter with the Traxxas Link Wireless Module (part #6511, sold separately).

649,-

699,-

KJØP
-7%
LiPo Cell Voltage Checker/Balancer (2968X)  The Traxxas LiPo Cell Voltage Checker/Balancer connects to Traxxas LiPo batteries using the included balance lead adapters. Use the LiPo battery checker to view individual LiPo cell voltages and overall battery charge in the field without a charger. The battery cell checker works with 2, 3, and 4-cell Traxxas LiPo batteries and alerts you when a battery cell is out of balance. Built-In Balancer  A voltage balance function equalizes individual cell voltages to keep your LiPo battery in good condition.  NOTE: Do not attempt to use the battery adapters for charging or any purpose other than adapting Traxxas iD batteries to the cell voltage checker.  

439,-

469,-

KJØP
-6%
Micro switch harness with 4 AAA Battery box

85,-

KJØP
This is the Warn 1/10 scale Wireless Remote/Receiver Winch Controller Set from RC4WD. FEATURES For use with the RC4WD Bulldog 9300XT, and the WARN 9.5CTI winches 2.4GHz technology Heavy duty drive circuit Over 10' (3.04m) range Simple hookup INCLUDES Wireless Remote with Battery Receiver 6" (152mm) Battery/Receiver Power Wire 6" (152mm) Receiver/Winch Control Wire SPECIFICATIONS Receiver; Battery Compatibility: 2 and 3 cell LiPo Operating Voltage: 6 - 11.1V (see Comments) Length: 1.6" (40.4mm) Width: 1.2" (30.2mm) Height: 0.37" (9.4mm) Weight: 0.5oz (14g) Wires; Length: 6" (150mm) Wires Weight: 0.14oz (4g) COMMENTS This Wireless Remote/Receiver is not waterproof. Some Lipo battery voltage can be higher than 11.1 volts. Please be careful and check voltage before using your battery. Use a BEC if needing to use a 3 cell lipo.

595,-

KONTAKT
Motor, Titan 550, reverse rotation (21-turns/ 14 volts) (1) The Titan® 550 reverse-rotation motor is a 21-turn fan-cooled 550 size powerhouse capable of handling 14.4 volts. This powerful motor has a 30% longer armature than a standard 540 size motor for extreme monster torque. SPECS:    Length to end of armature: 78mm (3.07")           Diameter of can: 38mm (1.5")           Length of motor leads: 75mm (2.96")           Shaft diameter: (3.2mm) 0.125" COMMENTS: For the standard rotation motor, order TRX 3975.

289,-

299,-

KJØP
-3%
This is the Driver Figure for Tamiya 1/14 scale Tractor Trucks.     FEATURES Molded plastic construction, white in color  May be attached with double sided tape or cement   INCLUDES Leg, Arm, Head and Torso sections with Instruction Sheet   REQUIREMENTS Painting with Tamiya acrylic paint if desired   SPECIFICATIONS  Approximate Height from Sitting Position: 1.2" (30mm)

109,-

KJØP
This is a pair of RC4WD Hauler 1.7" Commercial Semi Truck Tires. FEATURES Fits all 1/14 scale RC4WD & Tamiya tractor semi truck wheels X5 hard compound Mini rib sipes for absorbing rib edge stresses Superior traction on wet surfaces Fits the RC4WD Diesel, Force and General front and rear wheels, and the RC4WD Boulder rear wheels INCLUDES Two Hauler 1.7" Commercial Semi Truck Tires and Foam Inserts REQUIREMENTS Tire Glue SPECIFICATIONS Outer Diameter: 3.28" (83.5mm) Width: 0.87" (22mm) Inner Diameter: 1.71" (43.5mm) Weight: 1.2oz (34g) each tire

159,-

KJØP
 This is a 100ml Spray Can of Synthetic Lacquer Paint from Tamiya. FEATURES: Cures in a short period of time.           Extremely useful for painting large surfaces.           100ml is enough to fully cover two or three 1/24 scale sized car             bodies.           Tamiya spray paints are not affected by acrylic or enamel paints.             Therefore, following the painting of the entire assembly, details             can be added or picked out using enamel and/or acrylic paints.  By             combining three different paints, the decoration of plastic             models will become simpler and more effective.           Available in 52 colors. INCLUDES: One 100ml Spray Can of Synthetic Lacquer Gloss Clear. REQUIRES: Eye, Lung and Skin Protection. COMMENTS: Highly Flammable, Pressurized Container.            Keep out of the reach of children.

109,-

KJØP
This is a 6" Long, Heavy Duty Y-Harness with Hitec S, JR, Airtronics Z Connectors. Features     Hitec 54701S Y-Harness 6"     Gold-plated teminals improve conductivity and prevent oxidation for     longer lifespan.     Heavier, 20-gauge wire handles higher current loads. Specifications     Fork in "Y" occurs 2" from the receiver connector     Overall Length: 6"     Connectors: one male and two female Contents     One 6" Long, Heavy Duty Y-Harness with Hitec S, JR, Airtronics Z Connectors

89,-

109,-

KJØP
-18%
This is the Robinson Racing Hardened 27 Tooth 48 Pitch Pinion Gear. FEATURES: Constructed of hardened machined steel        May be used on motors with a 5mm shaft including Traxxas, Associated and HPI models INCLUDES: 27 Tooth 48 Pitch Pinion Gear with 4mm Set Screw REQUIRES: 2mm hex wrench SPECS:    Number of Teeth: 27 Pitch: 48 Hole Diameter: 5mm Outer Diameter: 0.64" (16.2mm)       (11)

189,-

KJØP
This is the Motor and Gearbox for the RC4C 1/10 scale Warn 9.5cti Winch. FEATURES Assembled and ready to install INCLUDES Motor and Gearbox for the RC4C 1/10 scale Warn 9.5cti Winch SPECIFICATIONS Reduction Ratio: 1:380 Final Output: 52 RPM Total Length: 1.41in (36mm) Weight: 0.35oz (10g)

129,-

KJØP
Expedition rack, complete (includes traction boards, shovel, axe, jack, fire extinguisher, fuel cans, & mounting hardware)

569,-

629,-

KJØP
-10%
Mirrors, side (left & right)/ snorkel/ mounting hardware

99,-

KJØP
  • klarna-dark.png
  • vipps-orange.png
  • mastercard-full.png
  • visa.png
  • paypal.png