Traxxas

HPI 101228 Racing Axle 5x40mm (2)

Art.nr: 101228

139,-

Hpi Racing

Hpi Racing

** Ikke på lager

Du vil motta en e-post så snart produktet er på lager!

En feil har oppstått. Prøv igjen

Informasjon
Produsent

Informasjon

This is a pair of 5x40mm Axles for the HPI Savage XS Flux and Bullet Vehicles.

FEATURES:

Steel construction

INCLUDES:

Two 5x40mm Axles

Produsent

Hpi Racing

Hpi Racing

Kunder kjøpte også

Hovedbilde HPI 160544 SD-07WR

Hovedbilde HPI 160544 SD-07WR

HPI 160544 SD-07WR

HPI 160544 SD-07WR This water-resistant servo is ideal for bashers and racers looking for a tough and durable servo that can be used in wet conditions (e.g. rain, snow, puddles). Features: Operating Voltage: 4.8-6V 4.8V: Speed: 0.18 sec/60 degrees, Torque: 6kg-cm 6V: Speed: 0.16 sec/60 degrees, Torque: 7kg-cm Servo Spline: 25T Dimensions: Main case: 40x37.5x20.0mm (excluding mounting tabs, servo spline, & cable outlet) Mounting tab hole centres: 49.5.0x10mm Weight: 46g (excluding servo horn) NOTE: This servo is water-resistant only, meaning it is resistant to splashes and brief contact with water. It is not waterproof and therefore not suitable for submerged used. Before driving in wet conditions, make sure that all electronics fitted to the vehicle are safe to use (marked as water-resistant or waterproof), or that they are fully enclosed and protected from water and moisture (such as in a sealed receiver/battery case). Fans mounted on speed controllers are not water resistant - we recommend to disconnect the fan from the ESC before driving in wet conditions and allow it to dry fully before reconnecting the fan power. Lubricate exposed metal drivetrain parts such as bearings, outdrives and diff shafts before driving in wet conditions. Motors are not intended for submerged use and may be damaged if used when under water. After driving in wet conditions, make sure to rinse off dirt and any corrosive liquids like saltwater with plain water and re-lubricate metal drivetrain parts.

279,-

299,-

-7%

Hovedbilde HPI Racing 105817 Slipper Hub Set Savage XS

HPI Racing 105817 Slipper Hub Set Savage XS

HPI Racing Slipper Hub Set Savage XS

69,-

Hovedbilde Absima 2440015 Green Small Body Clips (10)

Absima 2440015 Green Small Body Clips (10)

Absima 2440015 Green Small Body Clips (10)

49,-

59,-

-17%

Hovedbilde HPI Racing 101226 Steering Nut 3mm (4)

HPI Racing 101226 Steering Nut 3mm (4)

This is the Steering Nut 3mm (4pcs) For the HPI Racing WR8 Car RTR FEATURES Steel construction INCLUDES Four steering nuts COMMENTS This nut can be installed on the 1/8 WR8 3.0 Ford Fiesta Rally Abu Dhabi RTR

59,-

Hovedbilde HPI 101227 Racing Flange Pipe (4)

HPI 101227 Racing Flange Pipe (4)

This is the Flange Pipe (4pcs) For the HPI Racing WR8 FEATURES Steel construction INCLUDES Four flange pipes COMMENTS This part is for the 1/8 WR8 3.0 Ford Fiesta Rally Abu Dhabi RTR

85,-

Hovedbilde HPI Racing 101209 Front Hub Carriers Left/Right 10 ...

HPI Racing 101209 Front Hub Carriers Left/Right 10 ...

These are the Front Hub Carriers for the HPI WR8 and Bullet Series. FEATURES: Plastic construction INCLUDES: Left and Right Front Hub Carriers REQUIRES: Four 5x10mm Ball Bearings (11)

99,-

119,-

-17%

Hovedbilde Traxxas 5115 Ball Bearings 5x10x4mm Revo (2)

Traxxas 5115 Ball Bearings 5x10x4mm Revo (2)

This is a 2 pack of 5X10mm Ball Bearings for the Traxxas Revo. FEATURES: Metal bearing construction Blue rubber dirt shields INCLUDES: (2) 5X10mm ball bearings, Part #5115 SPECS: Inside diameter: 3/16" (5mm) Outside diameter: 3/8" (10mm) Width: 5/32" (4mm)

49,-

Hovedbilde Traxxas 3647 Nuts 4mm Flanged Nylon Locking Steel (8)

Traxxas 3647 Nuts 4mm Flanged Nylon Locking Steel (8)

This is the Traxxas Flanged Nylon Locking Nuts. FEATURES: Steel serrated construction INCLUDES: Eiqht 4mm flanged nylon locking nuts SPECS: Outside diameter: 7mm

39,-

Hovedbilde HPI 106441 Racing Pin 1.65x10mm (10)

HPI 106441 Racing Pin 1.65x10mm (10)

Racing Pin 1.65x10mm (10) (11)

49,-

Hovedbilde Vant Battery 11.1V 4800mAh 50C Deans XH

Vant Battery 11.1V 4800mAh 50C Deans XH

4800mAh-3S1P-50C 11.1V Discharging connector: “Deans” Hardcase Størrelse: 138x 43x 30mm Lengde: 138mm Lende med ledningen: 143mm Høyde: 30mm Bredde: 43mm Bredde med ledningen: 47mm (der ledingen kommer ut på siden) Cable length: 125mm Vekt : 385 gram Passer blant annet på disse bilene. HPI Savage XS flux BSD Ramasoon

749,-

829,-

-10%

Hovedbilde Traxxas 7047R Spur Gear 55T VXL

Traxxas 7047R Spur Gear 55T VXL

This is the optional 55T Spur Gear for use on the Traxxas 1/16 E-Revo and Slash VXL Vehicles. FEATURES: Nylon construction Black in color INCLUDES: One 55T Spur Gear REQUIRES: Installation on the vehicle SPECS: Outer Diameter: 30mm (1.2") Inner Diameter: 5.5mm (0.22") Width: 7.2mm (0.28")

39,-

Hovedbilde Traxxas 2925X 1200mAh Power Cell NiMH Battery

Traxxas 2925X 1200mAh Power Cell NiMH Battery

NB!! Denne her erstatter TRX 2925 Traxxas Series 1 battery packs with iD auto battery identification are standard equipment in Traxxas 1/16-scale models. Like all Traxxas Power Cell packs, Series 1 batteries feature heavy-duty construction, flexible silicone-jacketed wires and Traxxas' high current connector for positive plug-in with zero-loss efficiency. 1200mAh capacity NiMH 6-cell 7.2-volt Series 1 Power Cell battery with iD auto battery identification, replacement battery for 1/16 Traxxas vehicles Genuine iD-equipped Power Cell NiMH battery packs make sure you experience all the performance that's been engineered into your Traxxas model Accessory Traxxas iD Auto Battery Identification chargers (sold separately) detect Traxxas iD Power Cell batteries and automatically set and optimize charge settings for unmatched charging safety and simplicity Type Battery Material NiMH Colour Black Width 7.5 cm Height 16 cm Depth 2 cm Weight 152 g

299,-

319,-

-6%

Hovedbilde Traxxas 6852A Driveshaft assembly, rear, extreme heavy ...

Traxxas 6852A Driveshaft assembly, rear, extreme heavy ...

Driveshaft assembly, rear, extreme heavy duty (1) (left or right) (fully assembled, ready to install)/ screw pin (1)

149,-

169,-

-12%

Hovedbilde Bronto 7.2V 3000mAh - Bronto SP - Ni-Mh - Tamiya plugg

Bronto 7.2V 3000mAh - Bronto SP - Ni-Mh - Tamiya plugg

7.2V 3000mAh - Bronto SP - Ni-Mh - Tamiya plugg Lengde - 135mm Bredde - 47mm Høyde - 24mm

295,-

Hovedbilde HPI 105913 - GT-2XS Truck Body Savage XS/Unpainted ...

HPI 105913 - GT-2XS Truck Body Savage XS/Unpainted ...

#105913 - GT-2XS TRUCK BODY SAVAGE XS/Unpainted body with precut decals. Customize your Savage XS with your own unique paint scheme using the crystal-clear GT-2XS truck body! Moulded from crystal clear polycarbonate plastic for high detail, extreme durability and low weight, this is a great way to instantly customize your Savage XS! The convenient pre-cut vinyl decal sheet includes: photorealistic headlights, grille, tail lights, official logos, window frames, door handles and more, all die-cut to make applying the decals quick and easy - there's no need to cut out the decals by hand! Overspray film and pre-cut vinyl window masks are included with each body. A decal instruction sheet is included for decal placement, and the body has dimple marks for body post drill locations. Photorealistic die-cut premium vinyl decals. The body has dimple marks for body post drill locations. Overspray film and pre-cut vinyl window masks make painting fast and simple Molded from strong clear polycarbonate plastic for durability and long life. THIS PART FITS THE FOLLOWING KITS / PARTS: Savage XS SS Savage XS Flux GT-2XS Savage XS Flux Ford F-150 SVT SAVAGE XS FLUX VGJR Savage XS Flux Chevrolet El Camino

349,-

Hovedbilde HPI Racing 106408 Wheely Bar Set

HPI Racing 106408 Wheely Bar Set

This is the Wheely Bar Set For the HPI Racing Savage XS Monster Truck FEATURES Black plastic construction INCLUDES One parts tree consisting of five parts Six screws in three sizes Two bearings Four locknuts in two sizes Installation instructions COMMENTS This wheely bar set can be installed on: Savage XS Flux 4WD Waterproof 2.4GHZ RTR Savage XS SS Kit

229,-

Hovedbilde HPI 109921 Racing HD Axle 5x40mm WR8 Savage XS Bullet

HPI 109921 Racing HD Axle 5x40mm WR8 Savage XS Bullet

This is a pair of optional Heavy Duty Axles. FEATURES Fits the HPI Bullet ST 3.0, Bullet MT 3.0, Bullet ST Flux, Bullet MT Flux and Savage XS Steel construction Reduces drivetrain wear and extends service intervals INCLUDES Two Heavy Duty Axles SPECIFICATIONS Length: 40mm Diameter: 5mm

199,-

Hovedbilde HPI 6819 Racing Silicone O-Ring P-3 Red

HPI 6819 Racing Silicone O-Ring P-3 Red

This is a Package of Red P-3 Silicone O-Rings for Hobby Use. These are used in shocks, absorbing vibration, and many other uses. FEATURES Silicone construction. INCLUDES Five P3 o-rings. REQUIREMENTS Nothing. These are direct replacement parts. SPECIFICATIONS Inner diameter: 3mm (0.20") COMMENTS These o-rings are not limited to use only in HPI vehicles.

39,-

Hovedbilde HPI 101293 Body Mount Set for Bullet Series

HPI 101293 Body Mount Set for Bullet Series

Body Mount Set for Bullet Series

139,-

Hovedbilde HPI 101239 Racing Pin 1.7x11mm

HPI 101239 Racing Pin 1.7x11mm

This is the Pin 1.7x11mm (10pcs) For the HPI Racing WR8 rally car FEATURES Steel construction INCLUDES Ten pins COMMENTS This pin can be installed on the 1/8 WR8 3.0 Ford Fiesta Rally Abu Dhabi RTR

29,-

Hovedbilde HPI Racing 101208 Front/Rear Upright Set Left/Right

HPI Racing 101208 Front/Rear Upright Set Left/Right

These are the Front Knuckles and Rear Uprights for the HPI WR8 and Bullet Series of Vehicles. FEATURES: Plastic construction INCLUDES: Left and Right Front Knuckles and Rear Uprights with four Hex Inserts (11)

159,-

169,-

-6%

Hovedbilde HPI 72275 Racing Shaft 3x60mm Silver (2)

HPI 72275 Racing Shaft 3x60mm Silver (2)

Passer til HPI XS Flux. (11)

35,-

Hovedbilde HPI Racing 105312 SHOCK TOWER/BODY MOUNT/ROLL BAR SET

Hovedbilde HPI Racing 105312 SHOCK TOWER/BODY MOUNT/ROLL BAR SET

HPI Racing 105312 SHOCK TOWER/BODY MOUNT/ROLL BAR SET

SAVAGE XS Genuine HPI quality spare part for easy maintenance and repairs.

219,-

229,-

-4%

Hovedbilde HPI Z663 Lock Nut M3 (6pc)

HPI Z663 Lock Nut M3 (6pc)

THIS PART FITS THE FOLLOWING KITS / PARTS: Vorza Flux Savage X 4.6 Baja 5SC Bullet ST 3.0 Bullet MT 3.0 Bullet ST Flux Bullet MT Flux Baja 5b SS Kit Savage XL Flux Baja 5b D-Box 2 Baja 5B Sidewinder X5 Baja 5B TSk-b Class 1 SAVAGE XS FLUX VGJR VENTURE TOYOTA FJ CRUISER GREY VENTURE TOYOTA FJ CRUISER... VENTURE Scale Builder Kit VENTURE TOYOTA FJ CRUISER MATTE... WR8 FLUX KEN BLOCK GYMKHANA FORD... WR8 3.0 KEN BLOCK GYMKHANA FORD...STD JUMPSHOT MT V2.0 JUMPSHOT SC V2.0 JUMPSHOT ST V2.0 Savage XS Flux Chevrolet El Camino...

45,-

Hovedbilde HPI Racing 105300 Steering Arm/Servo Saver Set Savage ...

HPI Racing 105300 Steering Arm/Servo Saver Set Savage ...

HPI Racing Steering Arm/Servo Saver Set Savage XS

109,-